RAMPS 1.4 Mechanical Endstops For 3D Printer / Limit Switch 3D Printer

Description

Reprap 3D Printer Mechanical Endstop Sensor Switch

Mechanical switch 3D printer limit switch
RAMPS 1.4 and supporting the use of plate with cable

Features:
It using 22AWG wire, copper wire inside is very thick, can be resistant to current 2A, 300V voltage. An insulating layer over a wide range of temperatures, up to 80 degrees. Is the common connection of thin copper wire can not match. Not easy to pull off, plug it convenient, for ease of use, plug the other side to do the one, you can use the direct plug.

Board Size: Approx. 39 x 16 x 7mm / 1.54 x 0.63 x 0.28 inch
Cable Length: Approx. 70 cm / 27.56 inch

Connection Description:
Red line connecting VCC (ramps of )
Connect the black wire GND (ramps of -)
Green Line connection SIGNAL (ramps in s)

Harga tertera untuk :
1x Mechanical Endstop For 3D Printer